Share
Pin
Tweet
Send
Share
Send
To create the box, we needed a 2 cm thick board, 2 metal-plastic sheets, 9 self-tapping screws, a grinding nozzle for a grinder.
1. Cut 4 sides from the board. Two of them have dimensions of 40 by 15 cm, another two - 25 by 15 cm.
2. On each board above and below we make grooves at a distance of 1 cm from the edge.
3. On one small side plate on top we do not make a groove, but cut the bar at a distance of 1 cm from the edge.
4. Using a grinder and a grinding nozzle, we grind all the details.
5. We begin to collect the box. Using screws, we fasten three walls. Attention, since our walls are quite thin, first we drill with a drill 1 mm thicker than the thickness of the self-tapping screw. We twist the screws into the holes. On each side we screw in 2 screws - above and below.
6. Cut out the bottom and cover of metal-plastic with parameters 38 by 23 cm.
7. Insert the bottom into the grooves.
8. We fasten the fourth side (with the trimmed edge).
9. Make a pen. It can be cut out of the bar, or you can buy a finished pen.
10. On the cover we put notes where the handle will be, drill holes. We fasten the handle.
11. Insert the cover into the grooves. We fasten the bar, which remained from the sidewall.
Our box is ready. In it you can put not only threads, but also other small items - cosmetics, jewelry, stationery, small children's toys and so on.
Share
Pin
Tweet
Send
Share
Send