HAIR CLIP-HAIR CLIP FROM ORGANZA "PRIMROSES"

Send

Such a flower is made of organza. The hairpin consists of two colors connected together. She is big, beautiful.

To work on the hairpin you will need:
- organza and sparkles.
- white organza.
- a soldering iron with a sharp tip.
- ten pearl beads.
- floristic wire.
- a thin ribbon for decoration of bouquets.
- thread with a needle.
- hair clip-hair clip large.
- glue gun.

First you need to prepare templates for the flower petals. We draw it in the shape of a droplet, but at the wide edge we make a cut four cm long and the drop itself is nine cm high and six cm wide. We take an organza and lay one on top of the other. We draw a hot soldering iron along the contour of the template, we get double-sided petals. And such petals will need 24 pieces.

In order for the petals to be lush and voluminous, it is necessary to collect each in a 4 cm section into a bunch.

We give all 24 petals a voluminous new shape.

Now we prepare two cuts of a thin ribbon for flower bouquets of 50 cm each, ten beads for pearls, two circles of dense white fabric with a diameter of 4 cm. Cut 10 pieces of floral wire ten cm long.

And we begin to create the middle of the flower. To do this, cut ten squares from the shiny organza with sides 7 x 7 cm.

Take one square at a time and start folding. First, add a square from corner to corner in half.

Then again we fold the triangle in half, angles to each other, we get a small folded triangle.

Add 5 squares in this way. And now we apply them to each other, grabbing the needle along the wide side of the triangle. It should be a short flight of stairs, where each subsequent petal starts from the middle of the previous one.

Now we take and tighten with a thread all 5 petals together. We get a small flower of five triangles.

It is time for the stamens. We make them from wire and beads. We put a wire into a bead. We bend it in half and twist the two edges of the wire together under a bead, we get five stamens in one flower.

Now from 0.5 meters of a thin ribbon we add a decoration of three curls and fix it. And from the second segment we make the same decoration.

We start picking flowers. First first. We take one circle of white fabric, divide it into four parts and put 4 points.

With a glue gun we fix the first four petals at these points.

Now we fix four more petals of the second row, placing them in a checkerboard pattern, relative to the first. Glue also the third row. At this stage, you will need to attach the decoration of their three curls.

While the glue dries, we fix five stamens in the middle of a small flower. It remains to stick this flower in the middle of the big one. The first flower is ready. Similarly, we do the second.